FCP6 Multi cam

i was just wondering if there was any changes to the positive in fcp6's multi cam feature.

I was hoping that it now had the ability to set in/outs to angles in the viewer. I mean setting in/out after you create the multi-seq.

i.e.
angle 1 -- in at 00.06.00.00
angle2 --- in at 00.04.00.12

and so on.

Sometimes its easier to set a sync-point when you can see the action in all shots. I do it old school currently by placing all angle on tl then push/pull til they sync. then i cut out what i want. I had tried to use it before but often times i run into stop/start problems made inadvertently or without conscience. I multi cam this means going back to square one with the sync.

""" What you do with what you have, is more important than what you could do, with what you don't have."

> > > Knowledge + Action = Wisdom - J. Corbett 1992 """"