Problem rendering Digital Anarchy Plug Ins

Posted by harry323 
Problem rendering Digital Anarchy Plug Ins
May 29, 2008 01:57AM
I believe that this problem has been caused by the latest QT update, but I'm not sure because, of course, I can't revert to my previous Quicktime version.

My Digital Anarchy plugins work fine before rendering. That is to say that I can apply the filter, adjust values and view it (pre-render) in slow motion preview mode.

However, after I render, I simply get black for the length of the effect

This happens under Tiger and Leopard ( I have two startup drives).

Has anyone else experienced this?

The manufacturers have answered emails and been courteous, but don't have a solution.

My setup:

Mac Octo, Blackmagic, FCS 6.0.3. Latest Mac System. Have run Disk Warrior, Disk utility, Clean installed entire system and FCS2 onto a brand new interior drive. No go. This is getting annoying.


Sorry, only registered users may post in this forum.

Click here to login



Web Hosting by HermosawaveHermosawave Internet

Recycle computers and electronics