|
Forum List
>
Café LA
>
Topic
Help fcp 5 Drop FramesPosted by spaceman
After creating a multiclip,
then inserting angles in the viewer (9) when I play from TL get the dreaded message (that i've not seen in FCPhd 4.5), "Dropped Frames" I did all that it instructed. Turn off Unlimited RT Lowered Compression rate closed open sequences (no other sequences to close) Lowered pref for RT Audio (even though no Audio) Can't figure out whats going on here. System is; OS 10.3.9 dual 2.5g G5 8g ram 2 Internal SATA Drives 1 500g G-Raid FCP 5 resides on one Internal SATA Clips are on G-raid (not on same drive as OS and FCP 5) Any ideas? or do I go back to 4.5?
maybe updating to Tiger would help.
i've been getting 9 angles splaying back ok on my 1.5G powerbook. the clips were on a LaCie FW800 drive. oh, yes, i had problems at first, as i was only using the FW400 port, silly me. everything weent fine when i switched over to FW800. hope that helps, nick
These are DV small test clips (QT Mov files) not exceeding 10mgs each ... I've tried 4 angles Same issue...
Tried all the RT settings with all combo's with the same results. Tried moving the clips to the other internal SATA drive where the OS and FCP 5 does not reside. same problem. Also trashed the prefs, did a safe boot, re-built permissions so many times I lost count. same problem... The G-Raid mentioned is FW 800 and has never shown this before. There's plenty of room on all Drives. The only thing I did not try that I can think of, is opening these clips in QT 7 and saving out as QT 7 files. Re-booted in FCPHD 4.5 on an other drive (internal SATA #2 running 10.3.5), used the same clips on different streams at the same time .. NO dropped frames.
Additionally, I turn off the drop frame message box (don't show again), it works to a degree.
When the sequence is in the viewer, it doesn't play (or make changes) in the canvas... When it in the TL, the times I can select different angles in the viewer when it's finished with the sequence, the edits or changes are in the timeline (all edited). I thought you are suppose to be able to make angle disissions before an edit.
Did you fix this problem yet? I got the same problem in my FCP 5. OSX Tiger, 400 GB Seagate sata. Please reply to sOOOOOOOOOO@comcast.net THX
Sorry, only registered users may post in this forum.
|
|