I scanned most of the previous posts and didn't see the problem I'm having, so please forgive me if I'm bringing up an old issue.
I was doing a batch capture of about 18 fairly small clips. At the end of the capture, FCP4 froze - I had to force quit, and of course, lost my clips.
Here is where the mystery begins....
After re-starting FCP4 and attempting to input my project again, the device control status read "not communicating."
I followed all the recommended procedures, checked all connections and settings. Nothing had been changed, nothing is unconnected, everything is normal. But, device control status STILL reads "not communicating."
Any ideas?