|
I have a project I have 5 sets and am doing the 3d camera slid thru.
seems simple in the tutorials. but all sets have same background. do I have to put same background in each set so the sets do not show thru on 3d canvas? Seems to do that now. is there a better ways to have sets and same background? I have bottom layer as background for all sets on top, like if it was a photoshop project would work fine. but 3d camera shows all sets thru at once. suggestions. thanks bill
I Have FCS 2 and motion 3 was installed...I was working on a project, I had all the footage on an external Hard Drive. I gave the External Hard Drive to a buddy to clean up project..he had FCS3 including Motion4 and offered me the upgrade...I said ok..I took it home to install it and realized I didnt have the Necessary Hardware (intel proc) to upgrade..I remember him saying "once I open this footage from FCP 7 it changes it and you wont be able to go back and open with your 6.0.6...
After aborting the upgrade I realize when I try to open my Motion 3 and the templates a window pops up saying "These templates were created by Motion 4" and it crashes.. So I tried to reinstall the motion 3 package and a window pops up, I should mention, I was so frustrated I threw Motion3 icon in the trash..and a new window says Motion 3 could not be installed on this computer (followed by)Could not find specific message for index 0 Can anyone help me reinstall motion 3 or tell me what I can do to get it back up and running? Brian-
Start from scratch. Uninstall all of FCS
[www.digitalrebellion.com] I have had to do this a few times and this program seems to work best.
Sorry, only registered users may post in this forum.
Moderators:
John Foley, Antonio Hui, markspencer, Tom Wolsky, Graeme Nattress, grafixjoe, Adolfo Rozenfeld
|
|