|
<HTML>Tried moving a project.
Played great. Looked great. But when I tried an effect--desaturate--and tried to render--got this strange message. "unable to render--not using the proper hardware card--codec not found" The project is DV using my GL1 as deck--I don't use a hardware card. Setups look the same. Any thoughts? Thanks so much, any help much appreciated, would love to move project over--think the color space and audio is better. Cy</HTML>
<HTML>Yes. Clean install. Even reinitialized hard disk.
In 1.2 got rid of all render files and rerendered with quicktime 5 RT. Was using DVtoolkit--think QT5 is better--all works great in 1.2. Do I need to upgrade QT5--have noticed a couple of incremental upgrades for it? Could I ouput an EDL and remake project? Seems painful--I suppose I would lose filter settings--color, audio. Maybe only straight cuts upgrade--any thoughts? Thanks Ruben, Cy</HTML>
<HTML>Thanks so much Michael and Ruben,
It was a settings problem--I had only inspected my settings in 1.2--seemed fine there but in moving them to 2--it picked up that I had once used DV plus codec from DVtoolkit. I had earlier changed to QT5 RT in 1.2 -- noticeable improvement. So as suggested I changed my sequence settings in 2 to DV and voila--render. Now-for my other question. I noticed that this project has a setting in it that I don't use any longer. For some reason I had set the DV fields settings to unknown. I always now use lower fields settings (think that is correct). I can reset everything to lower fields settings--should I do that--does it make a difference in DV? Thanks again so very much, Cy</HTML>
Sorry, only registered users may post in this forum.
|
|