|
I am sure this has to be a keyboard shortcut that i inadvertently hit.
i pulled a manually synced clip from a TL to another TL. The TL that i pulled it into is set to linked section. there were 4 audio tracks and 2 video. I deleted the unnecessary audio from a-trk 3&4 which corresponds to the video on v-trk 2. I highlighted the clip and modified the clip to a stereo pair. I bladed the clip to remove unwanted parts. Then i noticed that i had to cut both audio and video. So i checked the linked section button and it was activated. I did blade the clip into 3 sections. here is the weirder. The 3rd piece to the section behaves normally. Meaning when i click on either audio or video it highlights the whole clip with linked section activated. The other 2 sections behave differently. if i click the audio only the stereo pair highlights. If i click the video then only the video will be highlighted. v-trk 1 and a-trk 1&2 are from the same camera. if i double click the video to load to viewer only the audio or video will load. Other than dragging a box over both audio and video i can not get the 2 to behave as a full a/v clip. How do i get v-trk 1 to stay linked to a-trk 1&2? """ What you do with what you have, is more important than what you could do, with what you don't have." > > > Knowledge + Action = Wisdom - J. Corbett 1992 """"
Sorry, only registered users may post in this forum.
|
|